Software Input/Output Guide X11 Administration ... - paulmick.com

LD 16
Page 360 of 1050 Alphabetical list of prompts
Prompt Response Comment Pack/Rel
OPT4 For international COs, if the call originates from a CO
trunk type, add nothing. Otherwise, add PFX1 and
PFX2. OPT4 is the default for all Asia Pacific interfaces.
OPT5 This is the same as OPT4, except it supports a
maximum of 10 digits in the CLID. OPT5 is the default
for the Austrian interface.
CNEG Channel Negotiation bri-20
(NO) Channel Negotiation not allowed
YES Channel Negotiation allowed
CNEG is prompted if IFC = 1TR6, Numeris, APAC or
D70.
CNIE (NO) YES Request CNI after an ESN code is dialed.
The ESN code could be a Distant Steering Code
(DSC), Trunk Steering Code (TSC), NARS Access
Code 1 (ACI) or NARS Access Code 2 (AC2).
If NCNI > 0 and CNIE = YES, CNI is requested when
either one of the conditions is first met. CNIE is
prompted when the following occur:
• MFC package is equipped
• TKTP = DID or TIE
• MFC Table = R2MF
• MFC signaling table is defined for the route
553-3001-311 Standard 6.00 June 1999
dpnss-20
CNIT (NO) YES Call Number Identification Trace
Request MFC Call Number Identification digits only if
dialed station has MCTA Class of Service.
Prompted when the following occur:
1. MCT and MFC packages are equipped
2. TKTP = DID or TIE
3. MFC = R2MF
4. MFC signaling table is defined on the route
supp-15
CNTL (NO) YES Changes to controls or timers basic-1