Software Input/Output Guide X11 Administration ... - paulmick.com

LD 15
Alphabetical list of prompts Page 323 of 1050
Prompt Response Comment Pack/Rel
ROPT (NRO) No Route Optimization This option may be used to
suppress Route Optimization on switches which already
have high traffic.
RAX Route optimization is performed on calls which have
experienced alternative routing, been transferred or
have been extended by an attendant.
ROA Route Optimization after Alternative routing
ROX Route Optimization after Transfer and extension by
an attendant
dnwk-16
RPA (NO) YES Radio Paging Allowed rpa-20
RPNS (NO) YES Recall with Priority during Night Service supp-15
RR 0-511 RAN route number. ran-1
R_SIZE 1-512 Maximum number of ANI entries that can be configured
for incoming routes.
If is entered when REQ=NEW (new customer, it
defaults to 1.
After conversion it defaults to the number of ANI entries
for incoming route created during conversion.
The R_SIZE can’t be decreased if the entries are not
empty
cist-24
RTIM xxx yyy zzz Recall. Where:
• xxx = 0-(30)-378 (for Slow-Answer)
• yyy = 0-(30)-510 (for Camp-On)
• zzz = 0-(30)-510 (for Call waiting)
These timers indicate in seconds the elapsed time
before attendant recall. Slow Answer must be a multiple
of six seconds while Camp-On and Call Waiting must be
a multiple of two seconds, with odd numbers are
rounded down.
To change one timer all three fields must be input.
For recalls timed at the local node using the redirection
feature developed for DPNSS, no distinction can be
made between Call Waiting calls and Slow-Answer
recalls. The Slow-Answer value is used in both cases.
basic-1
X11 Administration