Software Input/Output Guide X11 Administration ... - paulmick.com

LD 17
Page 454 of 1050 Alphabetical list of prompts
Prompt Response Comment Pack/Rel
OPT5 This is the same as OPT4, except it supports a
maximum of 10 digits in the CLID. OPT5 is the
default for the Austrian interface.
CLOK Source of primary clock is either internal or external. pri-12
Prompted for ISL D-channels and ESDI synchronous
ports. Other D-channels are automatically set to
EXT.
EXT External Clocking.
When USR = ISLD, CLOK should be set to External.
Default for ISL D-channels is EXT.
INT Internal Clocking.
INT is used only during D-channel loopback tests,
where one side is set to INT, the other is set to EXT.
Default for ESDI AML ports is INT.
CMS 0-15 ESDI port number used for the CSL
Synchronous ESDI port number used for the CSL.
This must be the same value as the port number
defined at the ADAN prompt. Precede with X to
remove. Prompted when SYNC and USER = CMS.
553-3001-311 Standard 6.00 June 1999
cls-7
CNEG Channel Negotiation option ipra-15
(1) Channel is indicated and no alternative acceptable,
exclusive. Default value for all EuroISDN interfaces
except FRA interface.
2 Channel is indicated and any alternative acceptable,
preferred. Default value for all EuroISDN interfaces
except FRA interface.
CNEG is prompted when IFC = APAC, AXEA, AXES,
D70, NUME, SS12, ESIG, ISEG or TCNZ.