Software Input/Output Guide X11 Administration ... - paulmick.com

LD 17
Alphabetical list of prompts Page 497 of 1050
Prompt Response Comment Pack/Rel
RCVP (NO) YES Auto-recovery to primary D-channel option. RCVP is
supported on SL-1 to SL-1 connections only.
When RCVP = YES, the primary D-channel is
automatically forced to be the active channel after it
is brought up from a released state.
This option must be coordinated with the far end.
Both sides must be either YES or NO. If the two
sides do not match, both sides default to NO.
When IFC ¦ SL-1, RCVP changes to NO.
For Backup DCH only.
REMD Double Density Remote Peripheral Equipment
loop(s)
0, 1, 2, ...159 Meridian 1 loop or loops
G0,G1...G159 GEC loop or loops
T0,T1...T159 TVT loop or loops
Precede loop number with X to remove. If entry is for
an odd-numbered loop, the preceding even
numbered loop cannot be TDS, CONF or MFSD.
REMO Single Density Remote Peripheral Equipment
loop(s)
0, 1, 2, ...159 Meridian 1 loop or loops
G0,G1...G159 GEC loop or loops
T0,T1...T159 TVT loop or loops
Precede loop number with X to remove. If entry is for
an odd-numbered loop, the preceding even
numbered loop cannot be TDS, CONF or MFSD
REMQ Quadruple density Remote Peripheral Equipment
loop(s)
0, 1, 2, ...159 Meridian 1 loop or loops
G0, 1...G159 GEC loop or loops
T0,T1...T159 TVT loop or loops
Precede loop number with X to remove.
pri-13
rpe-1
basic-1
rpe-7
REQ CHG Request: Change existing data block basic-1
END Request: Exit overlay program
X11 Administration