Software Input/Output Guide X11 Administration ... - paulmick.com

ANFT
(CONT)
FAIL
ITDN
LD 16
Alphabetical list of prompts Page 353 of 1050
Prompt Response Comment Pack/Rel
Defines the ANI FAilure Treatment option.
Provide call to the required destination
Drop the call
Transfer call to the intercept DN defined by the ITDN
prompt
ANIC (NO) YES ANI Composing
Prompted for outgoing CIS route.
If ANIC=NO, old ANI composing is used: if the
originator of the call is a set, ANI message will consist
of the CAC of the originator + the LEC of the outgoing
route + the DN of the originator or the ANDN of the
outgoing CIS route, depending on the class of service
(DNAA/DNAD) of the set. If the originator of the call is
an incoming route, the components of the ANI message
are retrieved from default ANI entries and/or from the
data block of the outgoing CIS route.
If ANIC=YES, the following is done:
If no entry is associated to the calling set (ANIE=0),
then old ANI composing is used.
If an ANI entry is associated to the calling set (ANIE
has a non-zero value), but the associated ANI entry is
not configured, then old ANI composing is used.
If an ANI entry is associated to the calling set (ANIE
has a non-zero value), and the associated ANI entry is
ANIE (0)-x ANI table Entry for Route (configured under prompt
R_ENTRY, LD 15)
x= R_SIZE-1
R_Size is the maximum table entry number that can be
configured. (R-SIZE is defined in LD 15)
cist-24
cist-24
cist-24
ANKP (NO) YES KP signal suppressed cam-1
ANSZ (7)-15 Size of the ANI information
This is the length of LEC+ANI DN
For analog routes, the only valid response is 7
cist-24
X11 Administration