Software Input/Output Guide X11 Administration ... - paulmick.com

428
LD 17
LD 17: Configuration Record 1
LD 17
Issued: June 1999
Status: Standard
X11 Release: 24
Page 423 of 1050
System configuration defines system hardware and software parameters.
Overlay program 17 is used to modify the following parameters:
— passwords
— buffer sizes*
— number of CPU*
— voice or data loops*
— tone and digit loops*
— conference loops*
— memories*
— automatic maintenance routines
— teletypewriters and modem
— server configurations
* When modifying these parameters, the system must be initialized to effect
the change. After initialization, load Overlay 17 and check the amount of
unprotected memory before the data dump. When adding memory a
SYSLOAD is required. See the Conversion Procedures for parallel reload.
When the Overlay is loaded the available system memory and disk records
are output in a header as follows:
CFN000
MEM AVAIL: (U/P): xxxxxx USED: xxxxx TOT: xxxxxxx
DISK RECS AVAIL: xxx
DCH AVAIL: XX USED: XX TOT: 64
AML AVAIL: XX USED: XX TOT: 16
X11 Administration