iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (IP-PBX Features)
2.68 DISABLE OUTGOING CO ACCESS
Description
The Attendant can place CO lines out-of service, disabling outgoing calls on the CO path. This is
normally done in the event of an undetected fault interrupt service on a CO path. Incoming calls
continue to be processed normally.
Operation
Attendant
To disable/enable Outgoing CO access (toggle):
1. Press the [PGM] button.
2. Dial 04 (Attendant Station Program code).
3. Press the {CO} button of the line(s) to be disabled; confirmation tone is heard and the
selected line(s) changed to inactive status.
Conditions
1. If the desired CO line is in use, the Attendant may still disable the CO line; the feature will
take effect after the desired CO line returns to idle.
2. Once the line is disabled, the Attendant appearances for the disabled CO line will flutter at
240 ipm (inactive status), while other stations will show the CO line as busy (LED solid On).
3. The CO line outgoing access status is stored in battery-protected memory in case of a power
failure.
4. Multiple CO lines may be enabled/disabled without redialing the Attendant Station Program
code; confirmation tone is heard after each CO line is enabled/disabled.
5. Incoming calls on a disabled CO line will continue to operate normally.
Programming
Related Features
Attendant Position
Hardware
2.69 FEATURE CANCEL
Description
The Attendant can cancel features such as DND and Call Forwarding that are active at other
stations.
2-102