iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (DATA Features)
27. Kerberos key management 1293 – security related, for future use.
28. Kerberos 88 – for future use.
29. AUTH:113 request – an outbound packet for AUTH protocol has been accepted (for
maximum security level).
30. Packet-Cable – for future use.
31. IPV6 over IPV4 – an IPv6 over IPv4 packet has been accepted.
32. ARP – an ARP packet has been accepted.
33. PPP Discover – a PPP discover packet has been accepted.
34. PPP Session – a PPP session packet has been accepted.
35. 802.1Q – a 802.1Q (VLAN) packet has been accepted.
36. Outbound Auth1X – an outbound Auth1X packet has been accepted.
37. IP Version 6 – an IPv6 packet has been accepted.
38. iPECS SBG-1000 initiated traffic – all traffic that iPECS SBG-1000 initiates is recorded.
39. Maximum security enabled service – a packet has been accepted because it belongs to a
permitted service in the maximum security level.
40. SynCookies Protection – a SynCookies packet has been blocked.
41. ICMP Flood Protection – a packet has been blocked, stopping an ICMP flood.
42. UDP Flood Protection – a packet has been blocked, stopping a UDP flood.
43. Service – a packet has been accepted because of a certain service, as specified in the
event type.
44. Advanced Filter Rule – a packet has been accepted/blocked because of an advanced filter
rule.
45. Fragmented packet, header too small – a packet has been blocked because after the
defragmentation, the header was too small.
46. Fragmented packet, header too big – a packet has been blocked because after the
defragmentation, the header was too big.
63