iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (DATA Features)
6.4.4.2 Viewing and Editing the LAN Bridge Settings
After creating a bridge, you can view or modify its settings by clicking the bridge’s entry in the
‘Network Connections’ screen. The ‘LAN Bridge Properties’ screen appears.
Figure 6.30 LAN Bridge Properties
6.4.4.2.1 General
This sub-tab enables you to view the LAN bridge connection settings (see Figure 6.30). These
settings can be edited in the rest of the screen’s sub-tabs, as described in the following sections.
6.4.4.2.2 Settings
This sub-tab enables you to edit the following LAN bridge settings.
General This section displays the connection’s general parameters. It is recommended not to
change the default values unless you are familiar with the networking concepts they represent.
Since your gateway is configured to operate with the default values, no parameter modification is
necessary.
Figure 6.31 General Settings
Schedule By default, the connection will always be active. However, you can configure scheduler
rules in order to define time segments during which the connection may be active. Once a
174