iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (IP-PBX Features)
Operation
Operation of Distributed Networking is automatic when configured & defined
Conditions
1. To use the networking features, the software lock-key installation is required. Each iPECS
SBG-1000 system has a unique software lock-key. To get the software lock-key, contact
the distributor of iPECS SBG-1000 system.
2. Unified Dialing Plan (UDP): Each station can have a unique number up to 7 digits in the
networked systems, but it depends on their own numbering plan.
3. The alternative route employs a Speed Dial number to place a call and is not a Networked
call. Thus, the Distributed Control Network features are not available.
Programming
Related Features
Hardware
2.80.1.1 Net Call
Description
A station user can make a call to a station in other systems by dialing only a station number just as
an intercom call within the same system.
Operation
1. Lift Handset or press the [SPEAKER] button. The system provides a user with a dial tone.
2. Dial the station number of other systems, or press the {NET DSS} button of other systems.
3. The station seizes the network CO line according to the net routing table, and the system
sends a digit stream that is modified by the net routing table.
4. The called party receives a digit stream that is sent by calling party, and analyzes it using
the net routing table to determine
5. The right destination. The called station receives a ringing signal.
6. The LED of [Network CO] button will be extinguished when the Net Call is cleared.
Conditions
1. Net call must be used without seizing a CO line.
2. User hears an error tone if there is no idle networking path.
3. In spite of ICM mode, the called party receives a ringing signal for the networking call.
4. When system detects the fatal error from the network, system sends the digit stream to the
network using the alternate speed dial bin. In this case, the call is not a networking call.
Programming
VOICE INSTALL
CO Line Registration – Net Basic Attributes
2-117