iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (DATA Features)
6. Select the ‘Edit the Newly Created Connection’ check box if you wish to be routed to the
new connection’s configuration screen after clicking ‘Finish’. This screen is described later
in this chapter.
7. Click ‘Finish’ to save the settings. The new bridge will be added to the network connections
list, and it will be configurable like any other bridge.
The new bridge will be added to the network connections list, and it will be configurable like any
other bridge.
Note: Creating a WAN-LAN bridge disables iPECS SBG-1000’s DHCP server. This
means that LAN hosts may only receive an IP address from a DHCP server on the WAN.
If you configure a host with a static IP address from an alias subnet of the bridge
(192.168.1.X), you will be able to access iPECS SBG-1000 but not the WAN, as NAT is
not performed in the WAN-LAN bridge mode.
After creating a WAN-LAN bridge, you must also disable the IGMP Proxy on this connection. To do
so, perform the following:
1. In the ‘Network Connections’ screen under ‘System’, click the ‘LAN Bridge’ link. The ‘LAN
Bridge Properties’ screen appears.
Figure 6.169 LAN Bridge Properties
2. Select the ‘Routing’ sub-tab, and disable the ‘Multicast - IGMP Proxy Default’ option (to
learn more about this option, refer to Section 6.4.14.3.3).
3. Click ‘OK’ to save the settings.
244