iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (IP-PBX Features)
ATTRIBUTE DESCRIPTION RANGE DEFAULT
CO Release Guard Timer When a CO Line is returned to idle, the system will 010~150
020
deny access for this time to assure the PSTN
returns the CO circuitry to idle.
(100 msec)
CO Ring Off Timer
This timer sets the maximum ‘Off’ duration of the 001~150
060
incoming ring cycle for the Ring Detect circuitry of
the system to detect an abandoned call.
(100 msec)
CO Ring ON Timer
This timer sets the ‘On’ time of the incoming ring
1~9
2
cycle for the Ring Detect circuitry of the system to
recognize an incoming call.
(100 msec.)
Elapsed Call Timer
Users can receive a periodic tone indicating the
060~900
180
length of an outgoing call. This timer sets the time
before and between the tones.
(seconds)
Call Forward No Answer When a user activates No-Answer Forward, calls 000~600
015
Timer
will ring for this duration before being forward. The
Station No Answer timer will take precedence.
(seconds)
DID/DISA No Answer Timer A DID/DISA call to a busy station will forward to the 000~255
20
assigned DID/DISA Destination should this timer
expire.
(seconds)
VSF User Maximum Record This timer sets the maximum duration allowed for 000~999
60
Timer
the User Greeting in the system’s basic Voice Mail. (seconds)
VSF Valid User Message This timer sets the minimum duration allowed for a 0~9
1
Timer
voice mail message in the system’s basic Voice
Mail. Messages shorter than this duration are not
stored.
(seconds)
ICM Dial Tone Timer If a user goes off-hook on the Intercom and takes 01~20
10
no action for this timer, the user will receive error
tone.
(seconds)
Inter Digit Timer
This timer sets the maximum time allowed between 01~20
03
each user-dialed digit. At expiration, the user will
receive error-tone.
(seconds)
MSG Wait Reminder Tone An LIP Phone user will receive periodic reminder
00~60
00
Timer
tones of a message waiting at intervals of this
timer.
(minutes)
Paging Timeout Timer Determines the maximum duration of a page after 000~255
15
which the caller and Page Zone are released.
(seconds)
Pause Timer
A Timed pause of this duration is used in speed
1~9
3
dial and during other automatically dialed digits
sent to the PSTN.
(seconds)
SLT Hook Switch Bounce This timer determines the duration the system
01~25
01
Timer
considers an actual state change in the hookswitch
and not a contact bounce.
(100 msec.)
SLT Maximum Hook Switch This timer sets the maximum time an SLT user can 01~25
02
Flash Timer
depress the hook-switch for a Flash signal.
(100 msec.)
SLT Minimum Hook Flash This time sets the minimum time an SLT user must 000~250
008
Timer
depress the hook-switch for a Flash signal.
(10 msec.)
Station Auto Release Timer For an internal call, the system will return a station 000~300
060
to idle if the call remains unanswered for this
duration.
(seconds)
Prime Line Delay Timer This timer sets the delay (no action duration) for
01~20
05
delayed Prime Line operation.
(seconds)
Enblock Inter Digit Timer When an ISDN Line is assigned to send digits
01~20
3
Enblock, the system will send digits if the user dials
“#” or this Enblock inter-digit timer expires.
(seconds)
DTMF Duration Timer This timer establishes the duration of DTMF tones
sent on a CO line.
04~99
(10 msec.)
10
3-18