iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (IP-PBX Features)
3.2.1.8 Station Hold Music
iPECS SBG-1000 supports two types of Hold Music for Intercom calls. One type of MOH is Hold
Tone, and the other type is Record Play. A VSF announcement may be recorded and played as
MOH to the connected caller.
3.2.2 CO Line Data
3.2.2.1 Call Routing by Line
This page is enabled only when iPECS SBG-1000 has FXO ports (CSIU, CIU1 or CIU2 option
board is installed).
Each CO line is assigned to signal a station or group for an incoming call (Ring). Separate ring
assignments are made for Day, Night, and Timed Ring modes. When assigned to ring to a VSF
announcement, the call can be dropped automatically after the assigned announcement by
checking the “Auto Drop”.
When CO Lines are programmed to Ring to a VSF Group as an Automated Attendant, the Ring
signal can be on an immediate or delayed basis allowing other stations/groups to be assigned Ring
and answer prior to signaling the AA. The delay is defined in seconds from 00 to 30.
When a call is received, the system may use the ICLID (Incoming Caller ID) to route the call. The
system will delay routing a call for ICLID ring timer while awaiting ICLID. If ICLID ring timer is 0,
ICLID routing is disabled.
3.2.2.2 Call Routing by Called Number
This page is enabled only when iPECS SBG-1000 has BRI port (BRIU option board is installed).
These characteristics are required for proper operation of the system and BRI incoming call
destination selection.
Table 3.2.2.2 Call Routing by Called Number
ATTRIBUTE DESCRIPTION RANGE DEFAULT
Name of Called Number Name of Called Number
Route To (Day-Mode Period) Call routing destination in Day-Mode Station
Group 631
Route To (Night-Mode
Period)
Call routing destination in Night-Mode
Station
Group 631
Route To (Timed-Mode
Period)
Call routing destination in Timed-Mode
Station
Group 631
See Caller Number First Call is routing according to the ‘Call Routing by
Caller Number’ if caller number is matched
ON/OFF OFF
3-14