iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (IP-PBX Features)
3. Hang-up to return to idle.
To perform an Unscreened Transfer while on an ICM call:
1. Press [TRANS] button.
2. Dial Station to receive call.
3. Hang-up to return to idle.
OR
1. Press {DSS/BLF} button for the desired station.
2. Hang-up to return to idle.
SLT
While on a CO call, to perform a Screened Call Transfer:
1. Momentarily depress the hook-switch.
2. Dial the station to receive the transfer.
3. At answer or splash tone announce the call.
4. Hang-up to complete the transfer.
While on a CO call, to perform an Unscreened Call Transfer:
1. Momentarily depress the hook-switch.
2. Dial the station to receive the transfer.
3. Hang-up to complete the transfer.
To perform a Screened transfer of an active Intercom call:
1. Momentarily depress the Hook-switch.
2. Dial Station to receive call.
3. At answer or Splash tone, announce call.
4. Hang-up to return to idle.
While on an Intercom call, Unscreened call transfer:
1. Momentarily depress the Hook-switch.
2. Dial Station to receive call.
3. Hang-up to return to idle.
Conditions
1. The transferring station may camp a call at a busy station (refer to Camp-On).
2. The LED of a {LOOP} button will display the status of a call until the station no longer has call
supervision (ex., the call is successfully transferred).
3. To prevent Toll abuse, CO lines without an active call (either incoming or dialed digits on
outgoing) cannot be transferred.
4. For outgoing CO Line calls, the system will monitor the CO Line for dial-tone to prevent Toll
abuse; when an IP Line is seized, the system does not monitor for dial-tone.
5. While on intercom call transfer, the [ICM] button provides an appearance for the transferred
station; LED indicates status and pressing the button connects to the station.
6. A station in DND or out-of-service can not receive a transfer; any attempt will result in an
error tone.
2-12