iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (DATA Features)
The switch ports 1-4 will be used untagged port with VLAN ID 10. The ports 5-8 must be changed
to VLAN ID 10 and be set ‘Tagged’ port. Finally, you must configure ‘Port CPU’. The ‘Port CPU’ is
connected with ‘LAN Bridge VLAN 10’. The egress packets to ‘LAN Bridge VLAN 10’ must have
VLAN header with ID 10 to handle by the interface. Click of ‘Port CPU’ to edit VLAN ID. The
following screen appears.
Figure 6.258 LAN Switch Port CPU Settings
In this case, ‘Default VLAN ID’ will be used ‘1’. Click ‘New Entry’ to add port to a VLAN. The ‘Add
Port to a VLAN’ screen appears.
Figure 6.259 VLAN settings per port
Edit ‘VLAN ID’ to 10 and select ‘Tagged’ from ‘Egress Policy’ drop-down menu. And click ‘OK’.
iPECS SBG-1000 will request browser reloading.
Figure 6.260 VLAN Settings – Browser Reloading
Click ‘OK’ to proceed. After the ‘Port CPU Settings’ screen is back, the added VLAN ID appears in
the VLAN ID entries table.
287