iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (DATA Features)
Enabled Select this check box to automatically enable the daylight saving mode during the
period specified below.
Start A date and time when your time zone’s daylight saving period starts.
End A date and time when your time zone’s daylight saving period ends.
Offset A daylight saving time offset from the standard (winter) time.
If you want the gateway to periodically perform an automatic time update, proceed as follows:
1. Select the ‘Enabled’ check box under the ‘Automatic Time Update’ section.
2. Select the protocol to be used to perform the time update by selecting either the ‘Time of
Day’ or ‘Network Time Protocol’ radio button.
3. In the ‘Update Every’ field, specify the frequency of performing the update.
4. By default, iPECS SBG-1000 is configured with NTP Pool Project server for testing
purposes only. You can define another time server address by clicking the ‘New Entry’ link
at the bottom of the ‘Automatic Time Update’ section. You can find a list of time server
addresses sorted by region at http://www.pool.ntp.org.
If you wish to manually set the local time and current date, perform the following:
1. Click the ‘Clock Set’ button. The ‘Clock Set’ screen appears.
Figure 6.7 Clock Set
2. Adjust the settings as necessary and click ‘OK’. You are redirected back to the ‘Date and
Time’ screen.
6.3 Managing Users
The ‘Users’ menu item enables you to view and edit the defined user accounts.
160