iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (IP-PBX Features)
Analog CO
Where “Call Metering Pulse” service is available from the carrier, the system will apply the “SMDR
Cost per Unit Pulse” and the “SMDR Decimal” to the Call Metering received to estimate the call
cost.
When no “Metering Type” is selected, the system call duration is used with the cost/pulse and
decimal values to estimate the cost of the call. The cost is updated periodically using the “Elapsed
Call Timer” duration.
ISDN
ISDN providers may support “Advice of Charge” information in the ISDN Facility Message. If
assigned, the system will use this information to display and output call cost.
VoIP
For VoIP calls, the system uses the call duration, cost/pulse and decimal values to establish the
call cost estimate. The cost is updated periodically according to the “Elapsed Call Timer”.
Operation
System
Call cost is estimated automatically and output to LIP Phone displays and the SMDR TCP port
Conditions
1. The call cost display begins after the “SMDR Start Timer” expires, if enabled, or at receipt of
the first Call Meter Pulse.
2. Once connected to the system, the call duration includes the total time the call is connected
including periods when the call is on hold, in queue, etc.
3. To enable Call Cost Display, the “SMDR Cost per Unit Pulse” and “SMDR Decimal” must be
assigned; when not assigned, the call duration is provided by the system.
Programming
VOICE CONFIG
System Data – SMDR Attributes – Call Metering
System Data – SMDR Attributes – SMDR Cost Per Metering Pulse
System Data – SMDR Attributes – SMDR Decimal Position
System Data – SMDR Attributes – Record Start Guaranteed Time
Related Features
Hardware
SMDR (Station Message Detail Recording)
Lost Call Recording
Traffic Analysis
2-41