06.03.2015 Views

iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

<strong>iPECS</strong> <strong>SBG</strong>-<strong>1000</strong> <strong>User</strong> <strong>Manual</strong> (IP-PBX Features)<br />

SIP Phone<br />

To set-up the SIP Phone:<br />

1. Configure SIP Phone settings (ex. IP address, Subnet mask, Gateway, Telephone number,<br />

Proxy address, Expiration timer, Domain address etc.). The Telephone number must be the<br />

desired unused station number and also the proxy address and the domain address should be<br />

the <strong>iPECS</strong> <strong>SBG</strong>-<strong>1000</strong> IP address (refer to the SIP phone <strong>User</strong> Guide for further information).<br />

2. Boot the SIP Phone, which will register it with <strong>iPECS</strong> <strong>SBG</strong>-<strong>1000</strong>.<br />

Conditions<br />

1. Up to 6 SIP phones will be supported with Lock key. LG-Ericsson SIP extensions such as<br />

WIT-400H and LIP-8002 can be used without Lock key.<br />

2. Desired Number for SIP phone should exist in station number list and also should be not<br />

assigned for other extension.<br />

3. The Station <strong>User</strong> name will be overwritten by the SIP Phone Display Name setting.<br />

4. If the Station number is changed in the <strong>iPECS</strong> <strong>SBG</strong>-<strong>1000</strong> database, the SIP Phone should be<br />

reconfigured and re-registered with the changed telephone number.<br />

5. When SIP Phones are used with <strong>iPECS</strong> <strong>SBG</strong>-<strong>1000</strong>, service tones from the system will not be<br />

heard (Confirmation tone, etc.).<br />

6. <strong>iPECS</strong> <strong>SBG</strong>-<strong>1000</strong> can not support full system feature with SIP extension such as WIT-400H,<br />

LIP-8002 and etc. For example, tones and LCD display messages for SIP extension can not<br />

be fully controlled by <strong>iPECS</strong> <strong>SBG</strong>-<strong>1000</strong>.<br />

Programming<br />

VOICE MAINT<br />

VOICE INSTALL<br />

Appliances Control – Lock Key Install<br />

Station Registration – Registration Table<br />

Related features<br />

Hardware<br />

2.74 PRIME LINE IMMEDIATELY/DELAYED<br />

Description<br />

When a user goes to an off-hook state, the system normally provides ICM dial tone. If desired, a<br />

station can be assigned to access a pre-assigned system resource (Prime Line). The Prime Line<br />

can be any of the Idle Line Settings:<br />

• Seize a CO Line,<br />

• Call another station,<br />

• Activate a Flex button feature.<br />

Prime Line access can be defined as immediate or delayed. When assigned immediate, upon an<br />

off-hook event, the system provides access to the Prime Line. With Delayed Prime Line, the station<br />

2-109

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!