iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (DATA Features)
Figure 6.65 Enabled WPS
You can enter/change the value of pre-shared key at anytime by typing a different one in the field,
as well as change the type of the value to ASCII using the provided drop-down menu.
Status Indicates the WPS status. “Ready” means that the system is ready to negotiate with
incoming wireless clients, or “enrollees”.
Protected Setup Method iPECS SBG-1000 supports two setup methods, “Push Button” (the
default) and “Pin Code”. These are the methods used by wireless clients when seeking an access
point.
Push Button – The enrollment is initiated by either pressing a physical button on the wireless
client or through its software. After initiating the enrollment, click ‘Go’ for the devices to establish
a connection.
Pin Code – The enrollment is initiated by the wireless client’s software, which also provides a
pin code. To comply with this method, select this option from the drop-down menu. The screen
refreshes to provide a field for entering the pin code:
Figure 6.66 Protected Setup Method – Pin Code
In this field, enter the eight digit pin code provided by the wireless client’s software. Click ‘Go’ for
the devices to establish a connection.
When attempting to connect a wireless client to iPECS SBG-1000, you must be aware of its setup
method. A connection attempt will time out after two minutes if no connection is established. If a
connection is established, the ‘Status’ field will change to reflect that.
192