iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (IP-PBX Features)
Table 3.1 SIP ID Configuration Attributes
ATTRIBUTE DESCRIPTION RANGE DEFAULT
Table Utility
If registration is enabled (refer to Registration
USE/NOT NOT USE
Option) the iPECS SBG-1000 can send the User ID
to the SIP Proxy for registering the ID. Otherwise,
the Authentication user ID and password are used.
USE
Registration Option
In some situations (during provisioning of the SIP Register Provision
Server or Proxy), it may be desirable not to attempt
registration. This field may be used to determine if
registration should occur.
Provision
Register User Name User ID@Domain. 64
characters
Authentication User ID Authentication name assigned in SIP Proxy when
required for registration.
64
characters
Authentication User
Password
User password as assigned in SIP Proxy when
required for registration.
128
characters
Contact Number
User ID.
Name of Called Number Name of Called Number
Route To (Day-Mode Period) Call routing destination in Day-Mode Station
Group 631
Route To (Night-Mode
Period)
Call routing destination in Night-Mode
Station
Group 631
Route To (Timed-Mode
Period)
Call routing destination in Timed-Mode
Station
Group 631
See Caller Number First Call is routing according to the ‘Call Routing by
Caller Number’ if caller number is matched
ON/OFF OFF
3.1.3.4 Server Information
Various parameters must be entered for proper operation of SIP Trunking including SIP proxy and
Registration.
Table 3.1 Server Information Attributes
ATTRIBUTE DESCRIPTION RANGE DEFAULT
Proxy Server Address SIP Proxy server IP address. IP address
Proxy Server Port Default port for SIP messages to proxy. Port 5060
Proxy Registration Timer Time-out for registration. 3600
Domain
Domain name associated with VOIP channels. Is
used in SIP “TO: header message” to SIP Server.
Max 32
Characters
Required when the Proxy uses a port other than
5060.
SIP Pound Use ON: Send digit ‘#’ when user press ‘#’
OFF: The ‘#’ is used for sending complete.
OFF
ON
ON
CODEC Priority
Configuration
1st . priority
2nd. priority
3rd. priority
4th. priority
5th. Priority
1) If speficy priority to a specific CODEC then it will
work for negotiation RTP data.
2) If only 1st. priority is specified and the others are
none, then it will work as single CODEC only does.
none
g.711-u
g.711-a
g.723.1
g.729
g.729-a
none
3-5