iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (IP-PBX Features)
received caller number to entries in the Call Routing by Caller Number Table, and if a match is
found, will route the call to the destination defined in the Ring Assignment Table. Destinations can
be the VSF, a station or a station group.
Operation
System
System implements routing automatically based on database entries and the received caller
number.
Conditions
1. For analog CO Lines, the system will await receipt of valid ICLID for the ICLID Ring Timer. At
expiration of the timer, if ICLID is not received, the call is routed based on the type and other
programming (Ring assignments, etc.).
2. If the received caller number does not match an entry in the Call Routing by Caller Number
Table, the call is routed based on the type and other programming (Ring assignments, etc.)
for CO Line.
3. The caller number received from the CO Line may be a telephone number or name that must
match an Call Routing by Caller Number Table entry.
Programming
VOICE CONFIG
CO Line Data – Call Routing by Line
CO Line Data – Call Routing by Caller Number
CO Line Data – Ring Assignment Table
Related Features
Hardware
CO Ring Assignment
2.23 IP FAX RELAY, T.38 SUPPORT
Because of their nature, Fax tones do not transmit well through IP networks, particularly when
compression is employed. To address this, iPECS SBG-1000 supports the T.38 protocol that
defines the translation of fax tones to digital signals. When Fax tone is detected on a port of an
iPECS SBG-1000, the system will activate a T.38 Fax relay channel to the appropriate Line or SLT
module.
Operation
Operation of this feature is automatic.
Conditions
2-30