iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (DATA Features)
Figure 6.60 LAN Wireless 802.11n Access Point Properties – Enabled
Use the ‘Settings’ sub-tab to edit these parameters.
General This section displays the connection’s general parameters. It is recommended not to
change the default values unless you are familiar with the networking concepts they represent.
Since your gateway is configured to operate with the default values, no parameter modification is
necessary.
Figure 6.61 General Settings
Schedule By default, the connection will always be active. However, you can configure scheduler
rules in order to define time segments during which the connection may be active. Once a
scheduler rule(s) is defined, the drop-down menu will allow you to choose between the available
rules. To learn how to configure scheduler rules, refer to Section 6.9.3.
Network Select whether the parameters you are configuring relate to a WAN, LAN or DMZ
connection, by selecting the connection type from the drop-down menu. For more information,
refer to Section 6.4.1. Note that when defining a network connection as DMZ, you must also:
• Remove the connection from under a bridge, if that is the case.
• Change the connection’s routing mode to “Route”, in the ‘Routing’ sub-tab.
189