iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (DATA Features)
5. Select the ‘Edit the Newly Created Connection’ check box if you wish to be routed to the
new connection’s configuration screen after clicking ‘Finish’. This screen is described later
in this chapter.
6. Click ‘Finish’ to save the settings.
The new PPPoE connection will be added to the network connections list, and will be configurable
like any other connection.
Note: If your WAN connection is set to PPPoE when there is no PPPoE server available,
and a DHCP server is available instead, the device status will show: “In Progress – DHCP
server found, consider configuring your WAN connection to Automatic”
6.4.7.2 Viewing and Editing the Connection’s Settings
To view and edit the PPPoE connection settings, click the ‘WAN PPPoE’ link in the ‘Network
Connections’ screen (see Figure 6.11). The ‘WAN PPPoE Properties’ screen appears.
Figure 6.111 WAN PPPoE Properties
6.4.7.2.1 General
This sub-tab enables you to view the PPPoE connection settings (see Figure 6.111). These
settings can be edited in the rest of the screen’s sub-tabs, as described in the following sections.
6.4.7.2.2 Settings
This sub-tab enables you to edit the following PPPoE connection settings:
General This section displays the connection’s general parameters.
213