06.03.2015 Views

iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

<strong>iPECS</strong> <strong>SBG</strong>-<strong>1000</strong> <strong>User</strong> <strong>Manual</strong> (DATA Features)<br />

Figure 6.112 General PPPoE Settings<br />

Schedule By default, the connection will always be active. However, you can configure scheduler<br />

rules in order to define time segments during which the connection may be active. Once a<br />

scheduler rule(s) is defined, the drop-down menu will allow you to choose between the available<br />

rules. To learn how to configure scheduler rules, refer to Section 6.9.3.<br />

Network Select whether the parameters you are configuring relate to a WAN, LAN or DMZ<br />

connection, by selecting the connection type from the drop-down menu. For more information,<br />

refer to Section 6.4.1. Note that when defining a network connection as DMZ, you must also:<br />

• Remove the connection from under a bridge, if that is the case.<br />

• Change the connection’s routing mode to “Route”, in the ‘Routing’ sub-tab.<br />

• Add a routing rule on your external gateway (which may be supplied your ISP), informing of<br />

the DMZ network behind <strong>iPECS</strong> <strong>SBG</strong>-<strong>1000</strong>.<br />

MTU MTU is the Maximum Transmission Unit. It specifies the largest packet size permitted for<br />

Internet transmission. In the default setting, Automatic, the gateway selects the best MTU for your<br />

Internet connection. Select ‘Automatic by DHCP’ to have the DHCP determine the MTU. In case<br />

you select ‘<strong>Manual</strong>’ it is recommended to enter a value in the 1200 to 1500 range.<br />

Underlying Connection Specify the underlying connection above which the protocol will be<br />

initiated.<br />

Internet Protocol Select one of the following Internet protocol options from the ‘Internet Protocol’<br />

combo-box:<br />

• Unnumbered<br />

• Obtain an IP Address Automatically<br />

• Use the Following IP Address<br />

Please note that the screen will refresh to display relevant configuration settings according to your<br />

choice.<br />

Unnumbered Select this option to assign a predefined LAN address as <strong>iPECS</strong> <strong>SBG</strong>-<strong>1000</strong>’s<br />

WAN address. This is useful when <strong>iPECS</strong> <strong>SBG</strong>-<strong>1000</strong> operates in routing mode. Before selecting<br />

this option, configure the ‘Internet Protocol’ of your LAN device (or bridge, in case the LAN<br />

device is under a bridge) to use a permanent (static) IP address from the range of IP addresses<br />

214

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!