iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (IP-PBX Features)
2. During the registration of DECT phone, Monitor or Speaker button at the iPECS/iPECS SBG-
1000 attendant phone should not be pressed until the DECT phone completes the
registration and registration confirmation tone is heard.
Programming
VOICE INSTALL
Station Registration – DECT Registration
Related Features
Hardware
GDC-450H handsets
2.77 ALARM SIGNAL/DOOR BELL
Description
The system can be configured to recognize the status of an external contact (normally open or
closed). The system will signal to the Attendant Station when the contact activates. This capability
is commonly employed to provide remote Alarm or Door Bell signals to the user.
The Attendant Station receives the Alarm Signal, either a single tone burst repeated at 1-minute
intervals or a continuous tone. The Alarm Signal may be terminated at the user’s phone by dialing
the Alarm Stop code or, if assigned, pressing the {ALARM STOP} button. To rearm the Alarm
function, the alarm condition must be cleared and the Alarm signal terminated.
When used as a Door Bell, the Attendant Station receives a single tone burst each time the
external contact is activated and no reset is required.
Operation
System
At detection of contact operation, the Alarm/Door Bell signal is sent to assigned stations.
LIP Phone
To assign a Flex button as an {ALARM STOP} button to terminate the Alarm Signal:
[PGM] + {FLEX} + ‘65’ + [SAVE]
To terminate an Alarm Signal while idle:
1. Dial the Flex Numbering Plan code 65, confirmation tone is received and the Alarm
Signal is terminated. If the alarm condition is cleared, the system will automatically rearm
the alarm monitoring.
Or,
2. Press the {ALARM STOP} button.
2-113