06.03.2015 Views

iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

<strong>iPECS</strong> <strong>SBG</strong>-<strong>1000</strong> <strong>User</strong> <strong>Manual</strong> (DATA Features)<br />

6.4.17.5 VLAN Use Case<br />

<strong>iPECS</strong> <strong>SBG</strong>-<strong>1000</strong> enables you to partition an Ethernet-based network by creating segregated<br />

virtual networks. You can divide LAN ports per VLAN and insert VLAN header to egress packets.<br />

WAN also. In this Section, how to configure VLAN is described per case.<br />

6.4.17.5.1 How to use VLAN tag on WAN device<br />

If you would like to add VLAN header to egress packets and handle ingress packets with VLAN<br />

header like below figure, perform these following steps. This procedure was described based on<br />

default configuration.<br />

Figure 6.227 VLAN tagging use case on WAN<br />

Create new VLAN interface on WAN with VLAN ID 10 and set IP address to 10.10.10.1/24.<br />

Refer to Section 6.4.17.2 Creating a VLAN Interface. In the ‘Network Connections’ screen<br />

under ‘System’ (see Figure 6.11), click the ‘New Connection’ link. The ‘Connection Wizard’<br />

screen appears (see Figure 6.12). Select the ‘Advanced Connection’ radio button and click<br />

‘Next’. The ‘Advanced Connection’ screen appears. Select the ‘VLAN Interface’ radio button<br />

and click ‘Next’. The ‘VLAN Interface’ screen appears.<br />

Figure 6.228 VLAN Interface setting<br />

Enter a value that will serve as the VLAN ID, and click ‘Next’. The following screen appears.<br />

274

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!