iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (DATA Features)
6. Enter the IP address and subnet mask of the remote network that will be accessed via the
tunnel, and click ‘Next’. The ‘Connection Summary’ screen appears.
Figure 6.191 Connection Summary
7. Select the ‘Edit the Newly Created Connection’ check box if you wish to be routed to the
new connection’s configuration screen after clicking ‘Finish’. This screen is described later
in this chapter.
8. Click ‘Finish’ to save the settings.
The new IPIP tunnel will be added to the network connections list, and will be configurable like any
other connection.
6.4.15.2 Viewing and Editing the Tunnel Settings
To view and edit the IPIP tunnel settings, click the ‘WAN IPIP’ link in the ‘Network Connections’
screen (see Figure 6.11). The ‘WAN IPIP Properties’ screen appears.
Figure 6.192 WAN IPIP Properties
6.4.15.2.1 General
This sub-tab enables you to view a detailed summary of the IPIP tunnel settings (see Figure 6.192).
These settings can be edited in the rest of the screen’s sub-tabs, as described in the following
sections.
255