iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (DATA Features)
Refer to Section 6.4.17.4 Switch configuration. In the ‘Network Connections’ screen under ‘System’,
click the ‘LAN Ethernet’ link. The ‘LAN Ethernet Properties’ screen appears. Select the ‘Switch’ tab.
The ‘HW Switch Ports’ screen appears.
Figure 6.238 Switch tab of LAN Ethernet Properties
The switch ports 1-4 will not be changed because they belong to the default bridge (br0). The ports
5-8 must be changed to VLAN ID 10 and be set ‘Tagged’ or ‘Untagged’ port if you want egress
packets to tag VLAN header with ID 10. Finally, you must configure ‘Port CPU’. The ‘Port CPU’ is
connected with ‘LAN Bridge VLAN 10’. The egress packets to ‘LAN Bridge VLAN 10’ must have
VLAN header with ID 10 to handle by the interface. If the egress packets have no VLAN ID
(untagged), the packets will be handled by the default bridge (br0). Click of ‘Port CPU’ to edit
VLAN ID. The following screen appears.
Figure 6.239 LAN Switch Port CPU Settings
In this case, ‘Default VLAN ID’ will be used ‘1’. Click ‘New Entry’ to add port to a VLAN. The ‘Add
Port to a VLAN’ screen appears.
279