iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (IP-PBX Features)
After selecting the Type for a button, enter the appropriate value (Where applicable).
3.2.1.3 Paging Access
Each LIP Phone is assigned to be able to receive announcements from each Page Zone. A station
can be assigned to any, all, or no page zones. The iPECS SBG-1000 system supports up to 10
Internal Page Zones. By default, all stations are assigned to Zone 1.
NOTE: A station not assigned to any page zone will not receive any page announcements.
3.2.1.4 Mobile Extension Table
Selecting Mobile Extension Table will display the Mobile Extension data entry page.
A mobile phone can be used in conjunction with an LIP Phone. The Mobile phone can access
system resources available to the user’s wired phone and will receive ring for incoming iPECS
SBG-1000 calls. The user may be allowed to enable the Mobile extension and define the mobile
number. The system can be defined to employ a specific CO Line Group to place calls to the
Mobile phone. In addition, the mobile phone can be assigned to receive hunt group calls to the
primary extension. Also, parameters for notification of new VSF voice mails can be defined.
Table 3.2.1.4 Mobile Extension Table
ATTRIBUTE DESCRIPTION RANGE DEFAULT
Internal Access The user may be allowed to access internal call from the mobile Disable/Enable Disable
extension.
Usage The user can be allowed to register a Mobile phone number. Disable Disable
Mobile Ext
Fail Over
Hunt Enable When the paired station is a member of a hunt group (Circular or Disable Disable
Terminal), group calls can be sent to the active mobile extension. Enable
VSF/VMIM Enables outbound notification by the system when the VSF has
Not Use Not Use
Notify
unheard messages.
Use
Notify Retry Defines the number of attempts the system will make to complete 1 – 9 Times 3 Times
a notification when receiving busy/no-answer.
Retry Interval Defines the time between notification attempts. If a notification 1 – 3 Minute 3 Minute
fails, the system will retry after the timer expires.
CO Group CO group used to call the mobile extension. 0 ~ 5 01
Telephone
Number
CLI Number
Telephone number or CLI of the Mobile extension.
When the mobile Telephone number and CLI do not match, the
CLI entered here is used to authorize incoming calls from the
mobile.
Not assigned
Not assigned
3.2.1.5 Preset Call Forward
Stations can be programmed so that incoming CO and Intercom calls are forwarded to a preset
station or station group. This allows an external call or internal call to initially ring at a station and
forward to a pre-determined destination. Preset Call Forward can be separately assigned
3-12