iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (IP-PBX Features)
ATTRIBUTE DESCRIPTION RANGE DEFAULT
SMDR Decimal Position This value determines the position of the
0~5 2
Record Start Guaranteed
Time
Long Distance Code
SMDR CLI or Ring Service I
SMDR Ring/CLI/CPN Service
II
decimal in the Cost per Pulse entry above,
starting from the right most digit.
To allow for call set-up times through the
PSTN, a “Valid call timer” can be set.
For SMDR and COS purposes, five (5) Long
Distance codes of up to two (2) digits each can
be assigned. If dialed as the 1st digits, the call
is considered an LD call.
For incoming calls, the system will send the
defined data item for “Field I”. The data item
may be CLI, CPN or Ring Service Time. Note
the User dialed number is always provided for
an outgoing call.
For incoming calls, the system will send the
defined data item for “Field II”. The data item
may be CLI, CPN or Ring Service Time.
Print MSN
Print MSN number Information in SMDR
Record
Print Order No
Print record number as part of SMDR output,
will reset to 1 when SMDR capacity is reached
or SMDR Mail Auto Delete Set above is
enabled.
LCD Display Priority
Caller ID can be overwritten on Duration or
Cost LCD column or not.
SMDR ICM Save
When enabled, intercom call data is stored as
part of the SMDR data.
SMDR ICM Print
When enabled, intercom call data is printed as
part of the On-line SMDR.
SMDR Disconnect Cause When enabled, the disconnect cause is stored
in Off-line SMDR data and printed as parted of
the On-line SMDR.
SMTP Mail Server Address SMTP Mail server address to send e-mail
SMDR reports.
SMTP Mail Server ID
This field defines the user’s ID for SMTP Mail
server. If user’s ID and password is assigned,
SMTP Mail server will check the validation of
user ID and password.
SMTP Mail Server Password This field defines the user’s password for
SMTP Mail server. If user’s ID and password is
assigned, SMTP Mail server will check the
validation of user ID and password.
SMDR Sender Mail Address Sender e-mail address to send the SMDR e-
mail reports.
SMDR Receiver Mail Address Receiver e-mail address to receive the SMDR
e-mail reports.
000~250
(msec)
5 two digit LD
codes, use * as wild
card (any digit)
RING
CLI
CPN
RING
CLI
CPN
NONE
ON
OFF
ON
OFF
Caller ID
Duration / Cost
ON
OFF
ON
OFF
ON
OFF
100 Characters
Max 40 Characters.
Max 20 Characters.
000
RING
NONE
OFF
OFF
Caller ID
OFF
OFF
OFF
40 Characters -
40 Characters
3-21