iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (DATA Features)
your ISP of your newly installed equipment.
To override iPECS SBG-1000’s MAC address with that of the currenly connected modem or
network card, click ‘Clone My MAC Address’. The MAC address of device connected to iPECS
SBG-1000 will replace iPECS SBG-1000’s original one. Click ‘OK’ to save the changes.
You may also replace iPECS SBG-1000’s MAC address manually, by typing any valid MAC
address in the provided fields and clicking ‘OK’.
6.8.7 Diagnosing Network Connectivity
Click the ‘Diagnostics’ link in the links bar. The ‘Diagnostics’ screen appears.
Figure 6.293 Maintenance – Diagnostics
This screen can assist you in testing network connectivity and viewing statistics, such as the
number of packets transmitted and received, round-trip time and success status.
Note: The test tools described in this section are platform-dependent, and therefore may
not all be available at once.
6.8.7.1 Performing a Ping Test
Use the ‘Ping (ICMP Echo)’ section to to run a Ping test:
1. In the ‘Destination’ field, enter the IP address or URL to be tested.
2. Enter the number of pings you would like to run.
3. Click ‘Go’.
After a few moments, diagnostic statistics will be displayed. If no new information is displayed, click
‘Refresh’.
312