iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (DATA Features)
The following figure describes the IPSec tunnel setup, and contains all the IP addresses involved.
Use it as a reference when configuring your gateways.
Figure 5.107 Configuration Diagram
5.4.1.5.1 Network Configuration
Before you can set up an IPSec connection, you must configure both of the gateways’ LAN and
WAN interface settings. This example contains specific IP addresses, which you can either use or
substitute with your own.
• LAN Interface Settings
1. Under the ‘System’ tab, click the ‘Network Connections’ menu item. The ‘Network
Connections’ screen appears.
Figure 5.108 Network Connections
2. If your LAN Ethernet connection is bridged, click the ‘LAN Bridge’ link (as depicted in this
example). Otherwise, click the ‘LAN Ethernet’ link. The ‘LAN Bridge Properties’ screen
appears.
107