iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (DATA Features)
Figure 6.159 Internet Protocol Security (IPSec)
5. Enter the host name or IP address of the destination gateway.
6. Select a method for specifying the remote IP address, which serves as the tunnel’s endpoint.
Use “Same as Gateway” when connecting your LAN to a remote gateway. When connecting
your LAN to a remote network (a group of computers beyond a gateway), use one of the
remaining options. Also, use the transport encapsulation type in a gateway-to-gateway
scenario only. Upon selection of an option, the screen refreshes providing you with the
appropriate fields for entering the data.
a. Same as Gateway – The default option that uses the gateway IP entered above. When
selecting this option, you must also select the encapsulation type, tunnel or transport,
from its drop-down menu.
b. IP Address – The ‘Remote IP Address’ field appears. Specify the IP address.
c. IP Subnet – The ‘Remote Subnet IP Address’ and ‘Remote Subnet Mask’ fields appear.
Specify these parameters.
d. IP Range – The ‘From IP Address’ and ‘To IP Address’ fields will appear. Specify the IP
range.
7. Enter the IPSec shared secret, which is the encryption key jointly decided upon with the
network you are trying to access.
8. Click ‘Next’. The ‘Connection Summary’ screen appears.
Figure 6.160 Connection Summary
9. Select the ‘Edit the Newly Created Connection’ check box if you wish to be routed to the
new connection’s configuration screen after clicking ‘Finish’. This screen is described later
in this chapter.
239