iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (DATA Features)
Using the drop-down menus, select the component and severity level by which to sort the log
messages. Click ‘Apply Filters’ to display the messages in your specified criteria. You can add
more filters in the same way, or delete filters using their respective action icons. Defined filters
override the default filter that displays all messages.
Note: Clicking “Reset Filters” deletes all the defined filters without a warning.
Note that if you would like to view iPECS SBG-1000’s system log in your host’s command prompt,
you must install and run the syslog server. Then, configure iPECS SBG-1000 with your host’s IP
address as described in Section 6.2.
6.6 Routing
6.6.1 Managing the Routing Table
The ‘Routing’ screen enables you to add, edit, or delete routing rules from iPECS SBG-1000’s
routing table.
Figure 6.272 Routing
Note that this table only displays routing rules that you define manually using the WBM, and does
not display dynamic rules applied by iPECS SBG-1000’s network connection interfaces, such as
IPSec, OSPF, RIP, etc..
6.6.1.1 Adding a Routing Rule
To add a routing rule, click the ‘New Route’ link or the
appears.
action icon. The ‘Route Settings’ screen
293