iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (DATA Features)
Note: Do not leave the persistent logging feature enabled permanently, as continuous
writing of the log files to the Flash reduces gateway’s performance.
Outgoing Mail Server Configure outgoing mail server parameters.
Server Enter the hostname of your outgoing (SMTP) server in the ‘Server’ field.
From Email Address Each email requires a ‘from’ address and some outgoing servers refuse
to forward mail without a valid ‘from’ address for anti-spam considerations. Enter a ‘from’ email
address in the ‘From Email Address’ field.
Port Enter the port that is used by your outgoing mail server.
Server Requires Authentication If your outgoing mail server requires authentication check the
‘Server Requires Authentication’ check-box and enter your user name and password in the
‘User Name’ and ‘Password’ fields respectively.
Swap This feature enables you to free a portion of the RAM by creating a swap file on the storage
device connected to iPECS SBG-1000. This is especially useful for platforms with a small RAM. To
activate this feature:
1. Verify that a storage device is connected to iPECS SBG-1000.
2. Select the ‘Enabled’ check box.
3. In the ‘Swap Size’ field, enter a swap file size in megabytes.
4. Click ‘Apply’. A swap file is created on the storage device, and the feature’s status changes
to ‘Ready’.
Host Information iPECS SBG-1000 can auto-detect its LAN hosts’ properties, available services,
traffic statistics, and connections (for more information refer to Section 4.1). To enable this feature,
select its check box.
Installation Wizard Select the ‘Use Installation Wizard Pre-configured Values’ check box to have
the wizard skip the steps for which parameters had been preconfigured and saved in factory
settings file (rg_factory).
6.2.2 Setting the Date and Time
The ‘Date and Time’ menu item enables you to configure your gateway’s time, date, time zone and
daylight saving (summer time) settings.
158