iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (DATA Features)
field of a client’s certificate should contain an existing username, to which administrative
permissions are assigned.
System Logging Configure system logging parameters. You can view the system log in the
‘System Log’ screen under ‘Monitor’ (refer to Section 6.5.3).
System Log Buffer Size Set the size of the system log buffer in Kilobytes.
Remote System Notification Level By default, the ‘None’ option is selected, which means that
iPECS SBG-1000 will not send notifications to a remote host. To activate the feature, select one
of the following notification types:
• Error
• Warning
• Information
The screen refreshes, displaying the ‘Remote System Host IP Address’ field.
Figure 6.3 Remote System Host IP Address
Enter the remote host’s IP address and click ‘Apply’.
Note: If you would like to view iPECS SBG-1000’s system logs on a LAN host, you must
first install and run the syslog server.
Persistent System Log Select this check box to save the system log to the Flash---the
gateway’s permanent memory. This will prevent the system log from being erased when the
gateway reboots. Note that by default, this check box is deselected.
Security Logging Configure security logging parameters.
Security Log Buffer Size Set the size of the security log buffer in Kilobytes.
Remote Security Notification Level The remote security notification level can be one of the
following:
• None
• Error
• Warning
• Information
Persistent Security Log Select this check box to save the security log to the Flash. This will
prevent the security log from being erased when the gateway reboots. Note that by default, this
check box is deselected.
157