iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (DATA Features)
Figure 6.208 VLAN Interface
Note: By default, all of the gateway’s physical LAN devices are enslaved by iPECS SBG-1000’s
LAN bridge. A VLAN cannot be created over an enslaved network device. Therefore, remove a
device from the bridge prior to creating a VLAN over it. To learn how to do so, refer to
Section 6.4.4.1.
Select the underlying device for this interface. The drop-down menu will display iPECS
SBG-1000’s Ethernet connections.
Enter a value that will serve as the VLAN ID, and click ‘Next’. If you choose to create the VLAN
over the LAN bridge, the following screen appears.
Figure 6.209 VLAN over LAN Bridge
Tagging This feature enables you to select whether to add a tag header (a 32-bit label serving
as a VLAN ID) to the frames transferred over the VLAN. When the ‘Untagged’ option is
selected, the VLAN is determined based on other information, such as the ID of a port on which
the data arrived (PVID). Select the relevant setting from the designated drop-down menu. If the
created virtual network is intended for VLAN-unaware hosts, it is recommended that you select
the ‘Untagged’ option. And if the “Tagged” option is selected and “LAN Ethernet” port is
checked, you must configure switch VLAN configuration as described in Section 6.4.17.4.
VLAN Ports You can select the LAN bridge ports on which you would like to enable the VLAN.
To enable the VLAN on a specific device port, select its check box. You can also select or
266