iPECS SBG-1000 User Manual

iPECS SBG-1000 User Manual (DATA Features)
i. Click the ‘Apply’ button and then click the ‘OK’ button to save this rule.
5. Configuring Individual Rule of Tunnel 2 (iPECS SBG-1000 to Windows XP):
a. Under the ‘IP Filter List’ tab of the ‘New Rule Properties’ window, select the ‘iPECS
SBG-1000 to Windows XP’ radio button.
Figure 5.103 IP Filter List
b. Click the ‘Filter Action’ tab (see Figure 5.99).
c. Select the ‘Require Security’ radio button, and click the ‘Edit’ button. The ‘Require
Security Properties’ window appears (see Figure 5.100).
d. Verify that the ‘Negotiate security’ option is enabled, and deselect the ‘Accept
unsecured communication, but always respond using IPSec’ check box. Select the
‘Session key Perfect Forward Secrecy (PFS)’ (the PFS option must be enabled on
iPECS SBG-1000), and click the OK button.
e. Under the ‘Authentication Methods’ tab, click the Edit button. The ‘Edit Authentication
Method Properties’ window appears (see Figure 5.101).
f. Select the ‘Use this string (preshared key)’ radio button, and enter a string that will be
used as the key (for example, 1234). Click the ‘OK’ button.
g. Under the ‘Tunnel Setting’ tab, select the ‘The tunnel endpoint is specified by this IP
Address’ radio button, and enter .
Figure 5.104 Tunnel Setting
h. Under the ‘Connection Type’ tab, verify that ‘All network connections’ is selected.
i. Click the ‘Apply’ button and then click the ‘OK’ button to save this rule.
j. Back on the ‘iPECS SBG-1000 Connection Properties’ window, note that the two new
rules have been added to the ‘IP Security rules’ list.
105