24.08.2013 Views

VISSIM 5.30-05 User Manual

VISSIM 5.30-05 User Manual

VISSIM 5.30-05 User Manual

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

5 Base Data for Simulation<br />

Parameter Meaning<br />

next connector is considered.<br />

COLLISION_TIME Minimum collision time gain (calculated with the<br />

desired speed of the vehicle) which is required<br />

for a change of the lateral position. The default<br />

= 2 seconds can be set to a lower value if<br />

vehicles should move laterally for smaller<br />

advantages, too.<br />

SPEED Minimum longitudinal speed [m/s] allowing<br />

lateral movement. The default = 1 m/s can be<br />

set to a lower value if vehicles should move<br />

laterally even if they have almost come to a<br />

standstill already.<br />

● Overtake on same lane: Select all vehicles classes that are allowed to be<br />

overtaken within the same lane by any vehicle of that class for which this<br />

parameter set is assigned. You can define also on which side they are to<br />

be overtaken (on left, on right or on both sides within the same lane).<br />

● Min. Lateral Distance: Minimum distances for vehicles passing each<br />

other within the same lane and for the lateral distance to vehicles in the<br />

adjacent lane are defined for each vehicle class to be passed. The<br />

distance is defined for standstill (at 0 km/h) as well as for 50 km/h. For<br />

other speed values, the appropriate minimum distance value is gained by<br />

linear interpolation. For those vehicle classes where no values are<br />

defined, the default definition applies.<br />

Example<br />

Bikes and cars travel on the same one-lane-link. Bikes are to drive on the<br />

right hand-side. Cars are allowed to overtake bikes on the left; bikes are<br />

allowed to overtake cars on the right, and other bikes on the left.<br />

This behavior is accomplished in <strong>VISSIM</strong> as follows:<br />

1. Create a new parameter set “Urban lateral” as a copy based on “Urban”<br />

behavior.<br />

2. Edit parameters:<br />

- [FOLLOWING] min. look ahead distance: from 0<br />

to 30m<br />

- [LATERAL] Overtake on same lane: Add new<br />

line and select vehicle class “Bike” to be<br />

overtaken on left.<br />

3. Create a new parameter set “Urban cycle” as a copy based on “Cycle-<br />

Track” behavior.<br />

4. Edit parameters in [LATERAL] Overtake on same lane:<br />

140 <strong>VISSIM</strong> <strong>5.30</strong>-<strong>05</strong> © PTV AG 2011

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!