VISSIM 5.30-05 User Manual

3.3.2.2 Properties & Options: Editing in Multiselect Mode
Selection of Network Elements
The properties of all selected links and connectors can be accessed by right
mouse click (for link evaluations, cf. chapter 11.11). The following attributes
can be changed (for details please refer to the sections Links and
Connectors in section 6.2.2.4):
● Behavior Type: If the original
values are not identical for all
links, select the entry 0 Keep old
values to retain these values for
all links.
● Display Type: ditto
● Gradient
● Thickness (3D)
● Link Evaluation
● Segment length of links
● Visualization (of vehicles)
● Label
● COST calls the Link Cost window
● LANE CLOSURE calls the Lane Closure window
● CONNECTORS calls the Connectors (Multiselection) window.
Here the following connector attributes can be edited additionally:
- Emergency Stop position
- Lane Change position
- Recalculate Spline: If this
option is active, you can either
keep the number of points
given by connector or you can
enter the new number of
points which is to be applied
for curve calculation to all of
the selected connectors.
- Vehicle class closure (for
Dynamic Assignment only)
- Direction: If two or more connectors within the selection have
different Direction values then the default is set to Keep Values (i.e.
all connectors remain unchanged). To change all connectors to the
same value, select the desired Direction.
User Manual © PTV AG 2011 53