VISSIM 5.30-05 User Manual

6 The Traffic Network
6.3.1.3 Editing
The Links & Connectors mode needs to be active.
Select Single-select:
There are two ways to select a single link or connector:
► Right-click outside of the VISSIM network calls the Links/Connectors
selection list: Left-click to select a link or connector and click DELETE,
ZOOM or DATA).
► Left-click on the link or connector within the VISSIM network.
If multiple links/connectors overlap each other at the click position, the
button (default shortcut TAB) may be used to browse through all links
and connectors at the mouse click position in order to select the desired
one.
Multi-select (Only for Edit attributes, Move, Delete) :
There are three ways to define active links or connectors for further editing in
the multi-select mode:
► Draw polygon (cf. section 6.1) or
► Use Display type filter (cf. section 5.5.2) or
► Use Link behavior type filter (cf. section 5.5.1).
Move Single-select:
1. Select link.
2. While holding down SHIFT, left click on the link and drag it to the desired
position.
Multi-select:
1. Select links and connectors.
2. Left click on the active elements and drag them to the desired position
while holding down left mouse-key.
190 VISSIM 5.30-05 © PTV AG 2011