VISSIM 5.30-05 User Manual

3 Program Handling
3.3.2 Multi-Select Mode (2D only)
Currently the multi-select mode is available for processing of network
elements being located completely within the selection:
► Editing certain properties of links and connectors
► Moving links, connectors and nodes
► Deleting links, connectors and nodes
3.3.2.1 Multiselection of Network Elements
► Keep left mouse-key pressed while spanning a rectangle.
All elements being located completely inside are selected:
- Links and connectors
- Node polygons
► Links/connectors can be added to the selection (independent of their
previous state) by pressing SHIFT while drawing the rectangular selection
box.
► Links/connectors can be removed from the selection (independent of
their previous state) by pressing CTRL while drawing the rectangular
selection box.
► Toggle functionality: Left-click the a single link/connector or node to add
the single element to the selection or to remove ir from the selection.
► The entire selection can be cancelled by clicking outside the selection
while pressing CTRL.
► All links/connectors in the selection can be moved by clicking inside the
selection.
Connectors that connect two selected links are moved together with the
corresponding links - even if the connector itself is not included in the
selection.
If intermediate points of a connector should not be moved (along with
the start and end points) such a connector needs to be deselected and
CTRL must be pressed while moving the selection.
► The following applies to nodes defined by link segments (exported from
VISUM)
- Segment nodes in the polygon are not highlighted as if being
selected.
- Their status selected / not selected cannot be changed by mouseclick.
- They are not affected by moving links - only the position of labels
may change.
- Even if being not selected, segment nodes inside the polygon are
deleted like selected polygon nodes.
52 VISSIM 5.30-05 © PTV AG 2011