24.08.2013 Views

VISSIM 5.30-05 User Manual

VISSIM 5.30-05 User Manual

VISSIM 5.30-05 User Manual

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Vehicle Record<br />

To calculate the total values for evaluations like Delay and Travel Time for<br />

the network it is possible to collect data for all vehicles and filter it to get the<br />

maximum values before the vehicle leaves the network. It is also necessary<br />

to collect the values from the vehicles remaining in the network at the end<br />

of the simulation.<br />

There is one evaluation called Total Time that returns the total time the<br />

vehicle spent in the network. This value is saved to file only at the last<br />

second before the vehicle leaves the network. This is also the time step<br />

that the delay time for that vehicle should be collected.<br />

For the vehicles still in the network at the end of the simulation their total<br />

time in the network must be calculated using their start times.<br />

Results<br />

The vehicle protocol file *.FZP consists of the following:<br />

► File title<br />

► Path and name of the input file (File)<br />

► Simulation comment (Comment)<br />

► Date and time of the evaluation (Date)<br />

► Version no. with Service pack no. and Build no. (<strong>VISSIM</strong>)<br />

► Brief description of output parameters<br />

► Data block<br />

The vehicle record file can contain any of the parameters listed below. The<br />

table also includes the abbreviations that will be used within the vehicle<br />

record file. Please note that some parameters will only report correct results<br />

if the corresponding optional module (such as Dynamic Assignment,<br />

Emission etc.) is installed.<br />

Generally, current (short/long)distance/speed/acceleration units set via<br />

VIEW - OPTIONS - [LANGUAGE &UNITS] are regarded for evaluation data output.<br />

This does not apply to world co-ordinates which are always recorded in [m].<br />

Please note: The units of those parameters with the particular unit<br />

mentioned in the column header abbreviation will not change.<br />

Parameter Definition Column Header<br />

Acceleration Acceleration during the simulation<br />

step<br />

Delay Time Difference from optimal (ideal<br />

(theoretical)) drive time (in s)<br />

Desired Direction Vehicle Info only: Desired Direction<br />

/ Next Link / Route End Coordinate<br />

Desired Lane Vehicle Record only: Desired Lane<br />

(by Direction decision)<br />

<strong>User</strong> <strong>Manual</strong> © PTV AG 2011 517<br />

a<br />

TQDelay<br />

DesLn

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!