VISSIM 5.30-05 User Manual

The 2D Graphics Mode
The color code is used to color each segment of a link (or lane, if applicable)
in the VISSIM network according to the online data of the selected
parameter, cf. section 4.1.2. Therefore, you can freely select the class limits
by parameter and the color by class. According to the color code settings,
each segment of a link or connector will be colored, even by lane, if
applicable, cf. section 4.2.3.1
The segment length can be set and display can be enabled or disabled either
for each link and connector individually in Standard mode or for multiple links
and connectors simultaneously in Multi-select mode, cf. section 3.3.2.
4.2.3.1 Viewing Aggregated Values of Vehicle Traffic
Click VIEW – OPTIONS... to open the Display Options window.
In the [VEHICLES] tab do the following:
1. Check option Aggregated Values
2. Click the CONFIGURATION button
3. Set the options
The color of a segment results from these settings.
● Parameter: The desired parameter
to be displayed by color code. If
no selection is available, press
LINK EVALUATION... to select the
desired parameter. The appropriate
unit appears underneath.
● Cumulative: If checked, data
being collected during the current
interval is added to the previous
value and the result is shown.
● LINK EVALUATION... calls the link
evaluation configuration window
(cf. section 11.11.) for parameter
selection and time interval defiition.
The selected parameters are
displayed in the Parameter list box
after the window is closed.
● Classes: Define the class limits
(upper limit belongs to the interval)
for the values of the selected
parameter and click the
associated color icon to the right
to set the color by class.
● Click DEFAULT CLASSES to restore
the default settings (limits/colors).
User Manual © PTV AG 2011 81