VISSIM 5.30-05 User Manual

7.1.8.7 Editing
Graphical
selection
Selection
in the Pe-
destrian
Routes
window
The Pedestrians Editor (Add-on)
automatically by routing decision. If the sum of shares is not 1 (100%),
VISSIM automatically norms the shares. Example: If a ratio of 1, 1, and 2
is specified for three routes belonging to a single routing decision, the
upper two routes will receive 25% each and the last one will receive 50%
of the flow.
● Maximum number of queuing pedestrians (only for partial routes with
route choice method Service point selection)
● Route choice parameters and Number of the pedestrians to be regarded
for travel time calculation (only for partial routes with route choice method
Travel time)
For all subsequent actions the Pedestrian traffic mode and the
Pedestrian Routes mode need to be active.
Display in the Pedestrian Routes mode:
► all defined routing decisions for pedestrians are shown as dark red dots
► all defined destinations are shown as dark green dots
Selection of a pedestrian routing decision:
1. Optionally left-click the area where the routing decision is located,
2. Left-click the routing decision:
- The selected routing decision is displayed as light red dot.
- The corresponding destinations are displayed as dark green dots.
Destinations belonging to other routing decisions are hidden.
Selection of a route starting from the selected routing decision:
1. Optionally left-click the area where the destination is located,
2. Left-click the destination:
- The selected destination is displayed as a light green dot,
- the route is displayed as a yellow band with intermediate point(s).
► Open the Pedestrian Routes window and select the appropriate tab for
display of all pedestrian routes and routing decisions of this type in the
network:
► Right-click outside of the VISSIM network calls the complete list of
routing decisions.
If a pedestrian routing decision is currently highlighted, the appropriate
routes will be listed in the Route List.
► Double-click on a routing decision.
If a route is currently displayed as a yellow band, the selected route will
appear color-shaded in the Route List.
Alternatively, a route´s destination can be double-clicked.
User Manual © PTV AG 2011 385