VISSIM 5.30-05 User Manual

6 The Traffic Network
Edit
curvature
Select link and choose the desired action for intermediate points:
► Create: Right click on the desired location within the link.
► Create spline: While holding down ALT, click left in the section (between
two points) were you would like to start the spline, drag the mouse to the
destination section of the spline and release the button there.
In the upcoming window, select the number of intermediate points
(including the start and end point of each section) and choose, if the
existing points should be kept. Option Keep current intermediate
points is only relevant in case of existing intermediate points.
The spline is drawn according to the direction of the first and the last
section of the link portion.
► Move: Select and drag it to the desired location. The link length is
automatically adjusted and displayed in the middle section of the status
bar.
► Delete: Move it onto another intermediate point. To delete a section of
points drag the last one of that section to the first one. All points between
the two will be deleted.
► Define different height value: While holding down ALT, double click the
point to enter the height.
Delete Single-select Mode:
Select link
► either in the network and click
- DEL or
- EDIT - DELETE
► or in the selection list, then click
DELETE.
Multi-select Mode:
► Define active links
► then click
- DEL or
- EDIT - DELETE.
► finally
- check option(s) and
- confirm OK in the
“Multiselection
Delete” window.
-
192 VISSIM 5.30-05 © PTV AG 2011