VISSIM 5.30-05 User Manual

6 The Traffic Network
Edit
curvature
Select connector. Choose the desired action for intermediate points:
► Create: Right click on the desired location within the link.
► Create automatic full spline: Double click on the connector and activate
the Spline option. All intermediate points are automatically relocated to
form a Bezier curve.
► Create automatic partial spline:
1. While holding ALT, press the left mouse button in the section
(between two points) were you would like to start the spline and keep
the button pressed
2. Drag the mouse to the destination section of the spline and release
the button there. The window Convert section to spline opens.
3. Select the number of intermediate points (including the start and end
point of each section) and choose, if the existing points should be
kept.
4. The spline is drawn according to the direction of the first and the last
section of the connector portion.
► Move: Select and drag it to the desired location. The connector length is
automatically adjusted and displayed in the middle section of the status
bar.
► Delete: Move it onto another intermediate point. To delete a section of
points drag the last one of that section to the first one. All points between
the two will be deleted.
► Define height value: While pressing ALT, double click on the point to
enter the height.
Delete Single-select:
Select connector
► either in the network and click
- DEL or
- EDIT - DELETE.
► or in the selection list and click
DELETE.
Multi-select:
► Define active elements,
► then click
- DEL or
- EDIT - DELETE.
► finally
- check option(s) and
- confirm OK in the
“Multiselection
Delete” window.
-
200 VISSIM 5.30-05 © PTV AG 2011