VISSIM 5.30-05 User Manual

Public Transport
Relative flow volume definition for pedestrians using PT stops with platform
edge:
For passengers which have been defined as pedestrians of a pedestrian
class, default data will be created in two cases:
► If a pedestrian area (either waiting area or platform edge) is assigned
to a PT stop for which no passenger volumes have been defined.
► For each automatically created platform edge.
According to the default data, any pedestrian arriving at the waiting area
within the time interval 0 – 99999 will board any vehicle of any PT line.
6.5.1.3 Editing For all subsequent actions the
active.
PT stops mode needs to be
Upon selection of the
dark-red frame:
PT stops mode, the PT stops are highlighted by a
Select You can select a PT stop either in the list or in the network display:
► Right-click outside of the VISSIM network calls the PT Stops selection
list: Left-click to select the stop, then click DELETE or ZOOM or DATA.
► In the network display: Click stop (dark-red): The polygon turns light-red.
Edit data
Move
► In the network display: Double-click to call the Edit PT stop window for
the selected stop.
► In the selection list: Select the stop, then click DATA.
► In the Edit PT stop window you can enter different At, Length and Lane
values. Link number and Type are not subject to changes.
► In the network display:
- A bus lay-by cannot be moved graphically
- Drag the selected street stop to another position within the same
link or into another link/connector while holding down left mousekey.
The polygon turns light-blue.
User Manual © PTV AG 2011 247