VISSIM 5.30-05 User Manual

11 Evaluation Types for Simulations of Vehicles
► Selected Parameters (use and to add or remove a selected parameter)
► Available parameters (Parameter Selection)
► Vehicle Class (enabled only for some parameters)
Use the buttons UP and DOWN to arrange the entries (columns in *.KNA data
file).
● Output: Select data type, e.g. as database table, if applicable:
- Compiled data: Creates an ASCII file *.KNA according to the
current settings in the window (parameters, vehicle classes etc.).
If VISSIM is started with command line parameter -s or if the
simulation run is started via COM with RunIndex set to a value >0,
the index of the simulation run will be added to the name of the
output file (*.KNA).
- Raw data: Creates an ASCII file *.KNR, does not regard userdefined
parameter settings.
- Database: If active, evaluation output of compiled and/or raw data
is directed to a database with the specified Table Name (rather than
to an ASCII text file *.KNA and/or *.KNR). The table name must not
be used for any other VISSIM database evaluations. In order to use
the database output the database connection needs to be configured
(cf. section 10.1.3).
The selected parameters and other settings are saved to a node evaluation
configuration file (*.KNK) when the window is closed via OK.
Filter
The evaluation can be
switched on/off
► separately for
each node via the
node attributes or
► via the list of
Active nodes in
the Node
Evaluation – Filter
window.
Furthermore, define
the following parameters
for delay measurements:
► the upstream Start of delay segment position,
► time period (From - Until) and
► length of the time Interval of the evaluation.
540 VISSIM 5.30-05 © PTV AG 2011