VISSIM 5.30-05 User Manual

6.6.1.2 Creating
Non-Signalized Intersections
As a priority rule always consists of at least one pair of cross sections, the
definition process is somewhat similar to static routes.
The definition of a priority rule is a four step process.
To initialize the process, select the Priority Rules mode. The next action to
be done is shown in the status bar. To go back one step, left click outside the
VISSIM network.
1. Select the link/connector where the stop line should be placed on.
2. Right click on the location for the stop line on the selected link.
3. Select the link/connector where the conflict marker should be placed on.
4. Right click on the location for the conflict marker. Typically it is located
within the last two meters of the conflict area. The Priority rules window
appears. Define the properties (as shown below) and confirm with Ok.
To define more conflict markers that belong to the same stop line, click twice
outside the VISSIM network to go back two steps and continue with steps 3
and 4 for each additional conflict marker.
To define a new priority rule, select the Priority Rules mode and repeat the
steps 1 to 4.
User Manual © PTV AG 2011 261